Synchronizing the carburetor throttle

From Jens Gran, the following tips on how to quickly and easily “sync carburettor dampers”:
You need the following tools: Screwdriver, Phillips screwdriver, pliers, hex wrench (included in the bike’s tool bag), welding wire 2 mm, lashing wire 0.5mm electricity. like.

– Check to four staples of welding wire with approx 35 & 25 mm long legs and 1.5mm between.
– Remove luftscoopen.
– Remove the airbox as follows: Loosen the four “slangklammersen” between the airbox and förgasasare. Remove the brackets (2 pcs.) For ventilation tubes (4 pcs.) To a chamber. Lift the airbox little bit, remove the two remaining rubber hoses, now you can remove the airbox.
– Press up vacumslidarna in the bottom position and secure them with the four staples.
– Screw the idle screw until 0.5 mm binding wire runs with just enough sluggishly between förgasarhals and the throttle in second carburetor (front left when you sit on the bike).
– When you thus “zeroed” Tvåans gasifier, you do the same with the remaining 3 by adjusting via the slotted screws on resp. damper shaft.
– When you are satisfied with the results, remove staples, turn on the airbox, scoops and tankdummyn. Note Do not forget to adjust the idle speed screw down. Smooth running.

Tips. Saving staples and binding wire so you can adjust the way, the gasses least once / year, and each time you loosened förgasarbryggan (a must).
Duration: approx. 1 hr.